KEBAFORM C 271 XFA
POM copolymer, non-reinforced, low viscosity, very low formaldehyde emission (< 1 ppm according to VDA 275) for applications in vehicle interiors. Formaldehyde emission remains very low (< 2 ppm according to VDA 275) even under unfavorable processing conditions (e.g. high melt temperature) or when colored.
POM - KEBAFORM
Under the trade name KEBAFORM, we market a wide product range of POM copolymers. KEBAFORM products are characterized by high strength and surface hardness, excellent chemical resistance and outstanding sliding and wear behavior. The product range includes basic grades with different viscosities, sliding and wear-optimized grades, variants reinforced with glass and carbon fibers, and various other modified compounds.
Typical areas of application
- dimensionally stable
- good chemical resistance
- good gliding properties
- High strength
- High wear resistance
- High weather resistance
Overview of product features
(May be required to remove surface moisture).
Dryer type: Dry air dryer
Temperature: 80 – 100°C
Drying time: 2 – 4 h
Melt temperature: 180 – 210°C
Mold temperature: 60 – 120°C (general guideline for technical parts: min. 90°C)
Back pressure (spec.): 10 – 40 bar
Injection speed: medium
Injection pressure: 600 – 1200 bar (depending on part and gate geometry)
Holding pressure: 600 – 1200 bar (depending on part and gate geometry)
General processing instructions:
The residence time of the melt in the screw antechamber should be kept as short as possible. In case of longer downtimes, an empty spraying of barrel and hot runner is necessary.
The information in this data sheet is based on our current knowledge and experience. Due to the wide range of possible influences during processing and application of our products, they do not exempt the processor from carrying out his own tests and trials. A legally binding assurance of certain properties or suitability for a specific application cannot be derived from our information.
* FE products are development products which are still in the trial phase. Technical data may still change in the course of product and process development. No final decision has yet been made on the commercialization of FE products. We reserve the right to discontinue the manufacture of FE products without giving further reasons.
Do you have
questions about our
products or services?
Then make an appointment with us.
Our team will be happy to advise you in a
personal conversation or by e-mail.