KEBABLEND / MW 53.2000 PPS
KEBABLEND / MW 53.2000 PPS is a PPS-based product for the manufacture of soft magnetic components. The achievable permeability is about 15 (at 1MHz) and the saturation flux density is 1200 mT.
PPS - KEBABLEND
KEBABLEND is a wide range of functional compounds, often tailor-made to customer requirements. Under the trade name KEBABLEND, we market magnetizable, thermally or electrically conductive compounds, high-density injection molding materials, compounds for radiation protection applications, detectable plastics and much more.
Typical areas of application
- Pumps and motors
- Electrical and electronics industry
- Household appliances
- Mechanical Engineering
- dimensionally stable
- high continuous used temperature
- soft magnetic
Overview of product features
Dryer type: dry air dryer.
Temperature: 120 – 130°C
Drying time: 2 – 3 h
Target moisture content: <0.02%.
Recommended basic settings:
Melt temperature: 300 – 330°C
Mold temperature: 140 – 160°C
Injection speed: medium – high
Holding pressure: high
Back pressure: 40 – 80bar (spec.)
Screw: special injection units for magnetic compounds; low compression screws with non-return valve
Nozzle: Open nozzle
Wear protection: Wear and corrosion protected according to machine manufacturer’s recommendation suitable for processing magnetic compounds
Injection unit: Shot volume = 50-80% of maximum metering volume
Further important processing information:
The residence time of the melt in the screw antechamber should be kept as short as possible. If this is not observed, segregation can occur due to the large difference in density between the filler and the carrier material if the downtimes are too high. The ideal here is metering time = cooling time. A medium back pressure leads to optimum homogenization. Due to the high filler content, the spraying equipment must be equipped with wear and corrosion protection.
The information in this data sheet is based on our current knowledge and experience. Due to the wide range of possible influences during processing and application of our products, they do not exempt the processor from carrying out his own tests and trials. A legally binding assurance of certain properties or suitability for a specific application cannot be derived from our information.
* FE products are development products which are still in the trial phase. Technical data may still change in the course of product and process development. No final decision has yet been made on the commercialization of FE products. We reserve the right to discontinue the manufacture of FE products without giving further reasons.
Do you have
questions about our
products or services?
Then make an appointment with us.
Our team will be happy to advise you in a
personal conversation or by e-mail.